@dosdont
Keep the videos coming please. Like with the z-axis buzzing sound myself and others are hearing on the A1 MINI, loudest at the end of the print when the z goes up.
@Roobotics
But oils degrade synthetic belts, why is there contact there that needs a lubricant? Car manufacturers who stuck rubber belts in their oil systems have been learning this lesson again lately. The belt starts to swell up and absorbs the oil while degrading. But maybe this is a low enough amount that it's fine. Certainly not as expensive to replace as in a car either.
@O99VR
Would you be able to push out an update that allows us to use the ams with the original spool holder? I have the p1s combo and that would be awesome!
@Fistach22
There is simpler solution to just print a small brick and place it on top of rear pulley bracket under this proximity switch that you removed. Switch will work and there will be no interference with belt that causes squeky noise
@lionblaze3522
What’s the eddy current coil for?
@PeterMaurer-d7z
Its a fix no repair ... all 4 weeks i have that nice problem!
@arangar57
Don't buy a 3D printer from them. They lie about the stock on their website. deadlines are not met
@jingboyuan8522
Customer service is a JOKE, and blocked me for asking too many questions.
@rzyto2173
Please make more guides but for a1 Combo😊
@PrintlyPerfect